This years holiday ornament was the most ambitious yet! Three interlocking PCBs to form a 3D snowflake, 140 LEDs and 3 months of design and build
Several animations were programmed and it goes to deep-sleep after an hour to extend battery life
1
7
Made these pins for a friend trip to Disneyland a few weekends ago. The LEDs are potted in resin that's tinted grey with a 3D printed border and lasts about 100hrs on a single CR2032
An STM32G031 drives the LEDs in a 4x4 matrix, there's a 3V boost to keep the brightness constant over discharge and an ALS for auto-brightness
Was inspired to do this project after seeing @chardane's awesome hats at #3HSF! xitter.gq/chardane/status/141141…
Before 2020, I had no desire to go to Disneyland. In 2021 tho? Heck yeah!
I couldn’t go without making 4 of these glowy hats for my quaranteam! 🥳 Made w/ @adafruit high density silicone bead LED strip (~160 LEDs per hat!) + a Trinket M0 on #circuitpython
Smol build saga👇🏽
Made a small production run of shark LED coasters for some coworkers. It fires the laser when you tap it when sitting flat, changes colour depending on the temperature and goes into full rainbow shark when you pick it up!
Ooh, new Espressif part with WiFi 6, BT 5 and a RISC-V core! This could be fun! espressif.com/en/news/ESP32_… #esp32c6
7
I hear 2009 was a great vintage and we all know flux only gets better with age! Who wants a gallon of the finest Kester 12-year?
2
9
A little bit of Boxing Day electronics assembly. Can’t beat a wonderfully purple @oshpark board with that crisp silkscreen and some good solderpaste
Testing my DCP405 modules that I’ve soldered for my @envox #benchbox3 and trying to calibrate but keep getting CC error on screen (even though LEDs show CV only). Any guesses, or do I just have some bad soldering somewhere? 🤔
1
7
I present to you: SMD Challenge, Extreme Edition
All passives 01005, a 555 timer in a DSBGA and 10 0201 LEDs on a 17mm diameter PCB
github.com/ftemperton/smd_ch…
Well that was a lot of fun! took about 30 minutes to solder. Didn't have a small enough banana, so rice for scale
Received my BB3 from @envox! Very excited but it seems like all the components fell off the PCBs in transit 🧐 Better get that order together! This is going to be a lot of fun


















