From the last couple of days
66432 at Balloch with 4D47/1340 Inverness-Coatbridge on 070225
37403+37409 at Carrbridge and Moy with 1Z37/0658 Carlisle-Inverness 'Capital Highlander' and
37409+37403 at Balloch with 1Z39/1642 Inverness-Carlisle on 080225 – at Scotland, United Kingdom
Yesterday I had the great honour of being at Freightliner Crewe for the rededication and naming of 90010 '275 Railway Squadron' with many former members of the Squadron.
Thank you to Freightliner and the efforts of Jez Fordham for enabling this to happen – at Crewe, England
Unusual visitor to platform 3 at Inverness! 08648 attached to a failed Inter7City set.
73969 and 66763 are in platform 2 with tonights Caledonian Sleeper set. – at Scotland, United Kingdom
When and how did the Americanisation of our language become normal?
.......fkin sulfur......
Jesus H Christ!
#Dumbingdown – at Scotland, United Kingdom
94
37418 back at Inverness today with Caroline with 2Z01/0732 Inverness - Lairg - Aberdeen – at Inverness, Scotland
66425 crossing the Findhorn Viaduct, Tomatin with 4D47/0443 Mossend- Inverness on 070924 – at Tomatin, Scotland
37510 and two barrier vehicles forming todays 5M57/0710 Inverness TMD - Derby RTC at Dalmagarry – at Tomatin, Scotland
Replying to @NSE_Latchmere @GlencoeMRG
If only! You have to insert a styrene pad to bring the chassis up to the correct height.
I refer to my earlier statement milud 🤣🤣 – at Scotland, United Kingdom
1
45
In eeeeeeWeeeeeek. On the patch I control/ signal! It's a long way as a passenger! – at Wick, Scotland
66034 crossing the River Ness with 1Z70/1004 Aviemore-Kyle Easter Highlander today – at Scotland, United Kingdom
£12.50 a pop isn't cheap! They're also an awkward fit, even to other Bachmann chassis.....a fair bit of surgery is required unfortunately!
Pics show one on a CEP chassis -I was going to do EPB 5358, hence the long white footboard... – at Scotland, United Kingdom
2
77
Replying to @NSE_Latchmere @hornby
I drilled through the axle boxes with a 0.5mm drill, cut away most of the internals of the bogie. Using the fine holes as a guide I got a bearing reamer to cut fine bearing recesses, going carefully until the 12mm Romford wheelsets rotated freely.
Much trial and lots of error! – at Scotland, United Kingdom
Replying to @ShedlyYard
Have you considered copper clad sleepers?
I laid the curved flexi track over the joints, cut away the sleepers and installed copper clad, screwed it down then soldered the rails to it. Used a slitting disc & dremmel to cut the rails and have had no problems 🙂 – at Scotland, United Kingdom
1
3
82






































