Inocious (@_Inocious_) profile picture

🇨🇵🔬 Cybersecurity lover. Hardware Pentest and Audit are my dope.

Joined October 2015
Okay so I can confirm that the glitch pin seems working. I get 1.25µs low for a 57ms period. (which is far less than 6.3 btw). Okay I will try to increase the glitch length then.
1
(2/2) Here my usb uart device :
1
(1/2) Yep, EVdd (sc p23) is connected to Vcc on my teensy (which provide 3.3V), while the Vdd (sc p22) is connect to my PD5 on teensy. Here you go for the pictures (I followed exactly the colors on the schematic) :
1
I can confirm that I get this reply : (the same answer is back again at the very end on the last two lines of the picture below). It's doing this in loop.
1